---

Installation time - 5 to 10 minutes. Don't hesitate to contact T-Design if have any questions!

Tools needed:
- screwdriver with T20 bit

1. Open the glove box. Opening it to a various degree - helps during installation.


2. Remove the side trim panel:
Start unclipping from the back. There will be 6 clips.
When you get to the front - bend the trim towards passenger door - to clear all 6 latitudal clips, and then pull back. The last 3 pieces near PCM are oriented front-back.


3. Remove the bolt near the front of the shift boot. Use T20 bit

4. Place bracket there with top plate looking towards passenger door. Make the bottom of the bracket parallel to the tab just below it. Put the bolt back.


5. Attach the supplied felt piece as shown in the picture.


6. Put the trim back. Insert front 3 thingies first, then clip the side clips. Opening glove box to various degree helps to create room.

7. Attach the ring with closed hole close to PCM, and open slot closer to the back of the car.


8. If need to create room for a passenger - unscrew the knobs and rotate the ring so the side trim is right in the middle of the circle. Rotating more than that might interfere with shifting gears. Also, you can always just remove the ring completely and throw it the glove box! Just keep the knobs screwed in the bracket, so not to loose them.